Replacing The Safety Filter Bag; Technical Data - Kärcher NT 801 B1 Instrucciones De Manejo

English
Replacing the safety filter
bag

3. Technical data

When replacing the filter it is important that the corresponding
safety measures are adhered to; e.g. the filter should be replaced
in the open and not inside an enclosed space, and a respiratory
protection mask should be worn if necessary.
• Release the container by pulling the retaining clips upwards.
• Lift off the blower assembly, and lay it on its back.
• Before disposing of the full filter bag screw the cap into the
connection sleeve, and seal the outer foil with tape.
Installation:
• Push the filter bag sleeve onto the elbow section in the container,
and pull the outer foil over the edge of the container.
• Remount blower assembly onto the container, and lock the
retaining clips in place.
Important: Ensure that the blower assembly is seated properly
(location); switch position - towards the rear.
Container capacity ........................................................................80 L
Weight ..................................................................................... 27.0 kg
Blower specifications ............................................. 230/1~ 50,60 V/Hz
Power consumption ................................................................ 1200 W
Vacuum ............................................................................... 220 mbar
Air flow .................................................................................. 57 L/sec
Length x width x height....................................... 640 x 510 x 935 mm
Cable length .............................................................................. 7.5 m
Class of protection ............................................................................ I
Interference suppression level .......................................................... N
Sound level (according to DIN 45635 Part 1) ...................... 74 dB (A)
Mains cable: order no. .........................................................6.647-410
type ............................................................................ H07RN-F3G1.5
* BIA Test Certificate No. 8801853/1110
Staubtechnisch geprüft nach ZH 1/487 und Hinweise SBM 1/85.
Average level of permeability < 0.1%; Verwendungskategorie C
measured with Test Aerosol 3 (Quarz dust) in accordance with
a) ZH 1/487, para 2;
b) DIN 24184;
c) DIN 53887;
d) BIA Notes on Dust Filter Equipment 1/85
NT 801 B1
13