AL-KO AMS Mammut Manual De Instrucciones página 13

Pay attention to the polarity (8)
4. Screw the cable screw connection of the battery cable into the housing, M12 (small). Tightening: into
the housing until the head makes contact.
5. Position the rubber seal and tighten the union nut. Tightening union nut: finger-tight and tighten a fur-
ther 1/4 turn with a spanner.
6. Connect the enable line (CAN bus cable) to the secured plug of the adapter.
Make sure that the plug/socket connection is correctly locked, or it will not work!
7. Remove the transport lock KB adapter CAN/enable.
8. Push the enable line (CAN bus cable) into the drive.
9. Screw the middle cable screw connection into the housing, M 20 (large). Tightening: into the housing
until the head makes contact.
10.Position the rubber seal and tighten the union nut. Tightening union nut: finger-tight and tighten a fur-
ther 1/4 turn with a spanner.
11. Screw the screw plug back in, tightening torque 4 Nm.
12.Connect the battery. IMPORTANT! Do not insert the fuse yet!
13.Connect all disconnected lines and plugs in the caravan.
14.Insert the fuse.
After the exchange, it is necessary to perform start-up as described in the instructions for use.
(See >INITIAL START-UP< in the original instructions for use)
15.Perform a function test.
en
13