Control Terminals - Danfoss VLT Compressor Drive CDS 803 Guia De Funcionamiento

VLT® Compressor Drive CDS 803
Operating Guide
Relay1
03
02
01
Relay2
06
05
04
Illustration 4: Relay Outputs 1 and 2

3.2.3.6 Control Terminals

Remove the terminal cover to access the control terminals.
Use a flat-edged screwdriver to push down the lock lever of the terminal cover under the LCP, then remove the terminal cover as
shown in the following illustration.
Illustration 5: Removing the Terminal Cover
The following illustration shows all the drive control terminals. Applying start (terminal 18), connection between terminals 12-27,
and an analog reference (terminal 53 or 54, and 55) make the drive run.
The digital input mode of terminal 18, 19, 27, and 29 is set in parameter 5-00 Digital Input Mode (PNP is default value).
20 | Danfoss A/S © 2021.06
Installation
AQ32174876762701-000301 / 130R0627