Publicidad
Step 17
å
Before fastening the DOOR to your unit, be sure the
mounting screw is against the stops as shown in the
right diagram. If it isn't, loosen the adjusting screw and
mounting screw to slide it against the stops. Then tighten
the mounting screw.
å
Fasten the RIGHT DOOR (P) to the LOWER END (B)
as shown in the lower diagram. Use the screws in the
HINGES. You should start each SCREW a few turns before
completely tightening any of them.
å
Fasten a PULL (149K) to the RIGHT DOOR (P). Use two
SILVER 5/8" MACHINE SCREWS (15S).
å
Repeat this step for the LEFT DOOR (Q).
å
See the next step for DOOR adjustments.
SILVER 5/8" MACHINE SCREW
(4 used for the PULLS)
Page 22
15S
427470
17
Stop
Mounting
screw
Adjusting
screw
Hinge
B
P
www.sauder.com/service
149K
Publicidad
