Twin-Star International 23DE9124 Instrucción De Montaje página 7

6. Locate Right Front Door (M) and Left Front Door (L).
Slide door hinge keyhole into panel hinge bracket.
(Diagram 1)
Use Phillips Head Screwdriver to tighten screws.
(Diagram 2)
TO ADJUST HINGES
To adjust door forward or backward change
keyhole slot position. (As Shown In Diagram 3a)
To adjust door right or left loosen / tighten screw.
(As Shown In Diagram 3b)
To adjust door up or down adjust bracket height.
(As Shown In Diagram 3c).
Attach the Knob (FF) to the Left Front Door (L) and
Right Front Door (M), use the bolts attached through
the pre-drilled holes in the doors. Then use a Phillips
Head Screwdriver to tighten the bolts.
Hardware Used
FF Knob (with bolt)
7. Choose desired height of Shelf (H) and place the
four Shelf Pin (DD) into same height shelf holes
inside side Panels. Insert Wood Shelf (H), allow
Wood Shelf (H) to rest on the Shelf Pin (DD).
Using Phillips head screwdriver tighten all Bolts
alternating top and bottom, left and right.
Hardware Used
DD Shelf Pin
8. PLEASE READ ALL "ELECTRIC FIREPLACE
INSERT" INSTRUCTIONS PRIOR TO INSTALLING
ELECTRIC INSERT IN YOUR COMPLETED
FIREPLACE MANTEL. INSTALL THE INSERT IN
YOUR FIREPLACE CLOSE TO ITS FINAL
POSITION.
Lift insert carefully into the back of the unit and
center in the insert opening. Do not drag insert
across Hearth/Base (A) as it may scratch your unit.
Attach Securing Block (N) to hold insert from back.
Using the Bolts (AA) through pre-drilled holes.
MOVE YOUR COMPLETED UNIT ONLY SHORT
DISTANCES. MOVE COMPLETED UNIT WITH
GREAT CARE. IT TAKES TWO PEOPLE TO MOVE
COMPLETED UNIT INTO ITS FINAL POSITION.
Hardware Used
AA
Bolt
Fig. 6
x 4
Fig. 7
x 8
Fig. 8
Completed
Unit
AA
x 1
6
L
H
DD
Electric
Fireplace Insert
FF
M
Install
Insert
From
Back
N