Tabla de contenido
Publicidad
Punching and binding
Preparations
•
Set the paper stop
Punching the sheets
Tip: We recommend testing the punch setting using a blank
sheet of paper before punching the original document.
Caution! To prevent damage to the punching
mechanism: Remove all metal parts (staples etc.)
from the document before punching. Do not punch
more than eight sheets of 80-gramm paper or one
film of 0.2 mm at the same time. Empty the cuttings
tray regularly.
•
Insert the sheets into the slot
•
While pressing the lock
lever
all the way down.
F
•
Move the lever up again and remove the punched
sheets.
•
Punch the remaining sheets in the same way.
Inserting and opening the comb
•
Determine the comb size required by means of the
table on the left hand page.
•
Place the plastic comb with the side to be opened
facing upwards into the binding mechanism
•
Pull the lever
down so far until the comb is
F
opened enough so that the sheets can be easily
inserted.
•
Press the lock
from left to right to hold the lever in
G
that position.
Inserting the sheets
•
Insert the punched sheets into the opened comb.
Removing the finished document
•
While pressing the lock
lever
backwards to close the comb.
F
•
Remove the finished document.
Specifications
Operating method
Paper size
Punching dies
Punching capacity
Plastic comb size
Net weight
Dimensions (W x D x H)
Subject to technical changes without prior notice.
to the paper format used.
.
B
from the right, push the
G
from right to left, push the
G
A, US letter, A5
21 rectangular (US pitch)
8 sheets (80 g/m² paper) or
1 transparent film (0.2 mm)
6–16 mm (up to 150 sheets)
370 mm x 120 mm x 90 mm
3 year guarantee
To be returned with the unit if defective.
LEITZ units are sold with a 3 year guarantee.
The conditions of the guarantee period of 3 years are as
follows:
1.
Each unit is guaranteed against all defects in material
and/or workmanship for a period of 3 years from the date
of purchase.
2.
No unit will be accepted without written notification from
the customer giving details of the problem that has
occurred, and proof of the date of purchase.
3.
All units for repair are to be returned to Esselte with
adequate packaging. No liability will be accepted by
Esselte for goods damaged in transit from the customer,
due to inadequate attention to packaging.
.
The supplier will be responsible for all parts and labour
charges as necessary to the unit. The 3 year guarantee is
subject to the following conditions:
a)
That the unit has been used strictly in accordance
with the operating instructions supplied with the unit.
b)
That if the benefit of this guarantee is sought, the unit
must be returned, carriage paid to Esselte. Esselte
does not accept responsibility for loss or damage in
transit.
c)
That the guarantee is invalid if the defects are found
to be caused by accident, misuse, alteration or
neglect.
.
d)
That no liability of Esselte is to be implied here for
damage, loss or expense of any kind resulting from,
consequence upon, or in any way due to any fault
whatsoever in the instrument or its accessories.
e)
That this guarantee does not affect you statutory
rights as a consumer.
Date of Purchase:
Model No. Serial No.:
Company Name:
Contact person:
Manual
Address:
Telephone/Fax No:
ESSELTE UK Ltd.
Waterside House, Cowley Business Park,
1.7 kg
Uxbridge, Middlesex,
UB8 2HP
UNITED KINGDOM
Tel.: 0870 9090609
Fax: 01895 878901
5
Publicidad
Tabla de contenido
