Publicidad
Idiomas disponibles
Idiomas disponibles
To install the swivels on your new siamese:
1 . Place the swivels over the siamese inlet adapters .
2 . Line up the hole in the side of swivels with the raceway in the siamese inlet adapters and insert the ball bearings (approximately 38
for 2 1/2" and 47 for 3") . As the raceways begin to fill, rotate the swivel back and forth to facilitate loading the required number
of ball bearings per groove .
3 . Install the swivel plugs .
4 . Check the swivels for smooth operation .
Note: Read operating instructions before use .
ISO 9001 REGISTERED COMPANY
2
PHONE: 330 . 2 64 . 5 678 or 800 . 2 28 . 1 161 I FAX: 330 . 2 64 . 2 944 or 800 . 5 31 . 7 335 I akronbrass . c om
WARRANTY AND DISCLAIMER: We warrant Akron Brass products for a period of five (5) years after purchase against defects in materials or workmanship . Akron Brass will repair or replace product
which fails to satisfy this warranty . Repair or replacement shall be at the discretion of Akron Brass . Products must be promptly returned to Akron Brass for warranty service .
We will not be responsible for: wear and tear; any improper installation, use, maintenance or storage; negligence of the owner or user; repair or modification after delivery; damage; failure to follow
our instructions or recommendations; or anything else beyond our control . WE MAKE NO WARRANTIES, EXPRESS OR IMPLIED, OTHER THAN THOSE INCLUDED IN THIS WARRANTY STATEMENT,
AND WE DISCLAIM ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE . Further, we will not be responsible for any consequential, incidental or
indirect damages (including, but not limited to, any loss of profits) from any cause whatsoever . No person has authority to change this warranty .
© Akron Brass Company . 2011 All rights reserved . No portion of this can be reproduced without the express written consent of Akron Brass Company .
REvISED: 6/11
Publicidad
