Ravelli Luna Manual De Uso Y Mantenimiento página 68

Use the UP/DOWN keys to change the value read by the
room temperature probe installed inside the handheld
set, with respect to a reference value.
Rev.0 18/07/2019
The value can vary from -10°C to 10°C.
The standard value is 0°C.
Pag.68
EN
VENTILATION menu (function only for models in which the same is specified in the dedicate user's manual)
The stoves equipped with ventilation system can heat the area in which are installed through the heat generated by the window and
the room temperature fan installed inside them.
Below are the messages shown on display when the stove is equipped with ventilation system.
The temperature read by the handheld unit controls the modulation of the stove. If you want to adjust the ventilation by
adjusting the stove, set the fan to A mode as shown in the relative chapter.
Press the key
"access menu" to
access the
MENU page
To exit the page and return to Stand-by page, press the button repeatedly.
Control: ventilation can be set from 0 to AUTO where 0 indicates that the same is disabled, setting from MIN to MAX enables selecting
the heat distribution speed. If set to AUTO, the ventilation follows the power set on the stove.
Stove phase general layout
Chrono function
PHASE
By enabling the chrono function, it is possible to control the ventilation speed for each program as shown in the logic above.
FINAL CLEANING
MENU
USER
SWITCH ON
MANUFACTURER'S
TECHNICIAN
Press the key
"access menu" to
WAITING FOR FLAME
access the
MENU page
WORK AT MAX P
ROOM TEMPERATURE
MODULATION
THE GRATE
ECO STOP
Use and maintenance manual Luna
MENU
USER
MANUFACTURER'S
TECHNICIAN
VENTILATION POW.
DESCRIPTION
The stove is in the switch off phase and the cooling phase has not been completed
yet.
The heater pre-heating phase has started and the pellets start to fall into the grate.
Press the key
"confirm"
The pellets ignite and take advantage of the heat in the intake air that passes
to access the
through the incandescent heater tube.
USER page
The stove has completed the switch on phase and runs at maximum set power
The room temperature set has been reached.
Brazier cleaning phase is active (periodic function).
With Climate Comfort active, the stove switches to automatic switch-off mode
when the room temperature set is reached (see the dedicated section).
By pressing the following key you will confirm of data
and switch to the page within SETTINGS menu
USER
POWER SETTING
CHRONOTHERMOSTAT
SCREW LOADING
SET AIR-PELLET
Press the key
"confirm"
to access the
USER page
Press the increase/decrease keys
"increase/decrease"
to change the ventilation.
USER
POWER SETTING
CHRONOTHERMOSTAT
SCREW LOADING
SET AIR-PELLET
CRONO-THERMOSTAT.
Press the key
"confirm"
to quickly switch to
VENTILATION.
USER
POWER SETTING
CHRONOTHERMOSTAT
SCREW LOADING
SET AIR-PELLET
Press the key
several times
to quickly switch to