Belshaw DOMIX 35 El Manual Del Propietario página 8

Switch on the doser using the external switch (or by plugging in the flying socket).
Set desired water quantity using
Increments/decrements may be obtained in three different ways:
1. step by step: pressing once
2. continuous: keeping constant pressure on + and - keys
3. fast: 3 seconds after keeping constant pressure on + or - key.
Press START key (8).
Water delivery may be stopped at any time by pressing STOP/C key (6). Quantity of water
delivered will then flash on display (12). To resume delivery of remaining water press START
key. Press STOP/C key and the original litre setting will reappears on display. Press STOP/C key
again to clear memory.
Water temperature is selected by turning the temperature regulation knob (5): the
temperature is shown on the electronic thermometer display (12). When regulating the
water temperature wait a few seconds between adjustments so as to allow the
temperature to stabilize.
Quantity in memory is retained at the end of each dosing. Simply press START key if identical
successive dosing are desired.
Memory is protected against power failure; pre-set dosing can be resumed pressing START
key when power is restored.
To ensure optimum operation the warm water temperature must be at least 10°C higher
than the required delivery water temperature and the cold water should be at least 5°C
lower. Low temperatures (below 10° - 15°C) may be obtained only when using a
refrigerator.
FAULTY OPERATIONS AND REMEDIAL ACTION
If during water delivery the litres display flashes and the buzzer sounds intermittently and no
water flows out of the DOX, press the STOP/C key and then the START key:
If no water flows out of the machine and after 10-12 seconds fault indication restarts,
check the water pipes and ball valve, probably water is not reaching the doser.
If the water pipes are not obstructed, the water taps are all open and water arrives
regularly to the doser, check that the filter (3) is clean and then press the START key. If the
fault persists, the solenoid valve coil is faulty.
Ask for technical assistance.
OPERATING INSTRUCTIONS
+ -
and
+ -
and keys
keys. Setting appears on display (13).
2600103/07.03.2003
3