Publicidad
FlushIQ
Product Overview
®
1
LED Flush Sensor / Indicator Light: This sensor on the tank is
used to flush the toilet, but will also function as the indicator light
to inform you of any issues with your product or what mode is
active.
2
Tank Level Sensor: This sensor inside the tank is used to detect
any changes in the level of your tank water. This will help deter-
mine if a leak is present.
3
Overflow Sensor: This sensor on the bowl is used to detect the
water level in the bowl. If water is detected at a certain level, the
toilet will no longer flush until the water drops to a safe level.
LED Color
Description
Normal Operation-
Solid Blue
Toilet is performing a flush/fill cycle.
Solid Yellow
Leak detected
Flashing Yellow
Leak detected (Tank Fill Failure)
Overflow level detected. Toilet
Flashing Red/Blue
will not flush.
Flashing Red
Low battery indication.
Toilet is in sleep mode. Toilet will
Flashing Blue
not flush.
Task
Hold hand within 2'' of sensor (1)
Flush
for 1/2 second.
Lift off tank lid and push down on
the red, manual flush rod (2). The
Manual Flush
tank will not automatically refill
after manual flush.
Remove battery box lid (3) by
twisting latch and pulling. Remove
old batteries. Install 4 "AA" bat-
teries in orientation shown. Note:
Positive terminals are to the left
Change Batteries
and negative terminals are to
the right. Remove box lid, old bat-
teries (3) and adapter (4) to install
"C" batteries for longer battery life.
Reinstall lid. (See page 5.)
Touch sensor (1) for 7 seconds.
Enter Sleep Mode
Toilet will not flush while in sleep
mode. Use for cleaning, etc.
Touch sensor (1) for 7 seconds or
Exit Sleep Mode
wait for the 10 minute time out.
Activity
1
2
1
"AA" Size Batteries
Baterías "AA"
Piles « AA »
3
5
3
2
"C" Size Batteries
Baterías "C"
Piles « C »
3
4
93675
Rev. A
Publicidad
