Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
them into each other. Do not whip out the pole sec-
tions so they snap together. Make sure that each
pole section is fully inserted into the next section;
otherwise they may crack or break under pressure.
Gently slide the poles through the pole sleeves.
Do not pull them through.
3. Erect the tent and make sure that the entrance zip
is not under undue tension or strain which could
easily damage the zip. Use the releasing lock or
hook at the bottom of the entrance.
4. Stakes should be driven in at a 45° angle away
from the tent (X).
The VAUDE Y-stakes that come with our tents
are very durable and resistant to bending and
especially suited for hard ground and grass. For
extremely hard ground, we recommend the use
of tent pegs or spikes. VAUDE offers special stakes
for very soft ground, snow or sand. Hammer them
in vertically for soft soil or bury them horizontally to
anchor in sand or fresh powder snow (Y).
SETTiNG UP – "modEL-SPECiFiC":
10
We advise that at least two people are available to
set up this tent. Please follow the instructions step by
step, the order is important.
1. Clear the ground of any sharp objects.
2. Lay out the set-up band in a circle (A).
3. Assemble the poles and insert into the central
connector.
4. Put one of the poles (1) into one of the eyelets
marked with red.
5. Put the opposite pole (1a) into the opposite
eyelet marked with red.
6. Insert the two poles in the middle (4 and 4a)
opposite each other. Put the remaining poles in
the corresponding locations, e.g. 2 and 2a, 5 and 5a,
3 and 3a, 6 and 6a.
7. After the insertion of all the poles throw over
the outer tent (B) and secure it at the base (C).
8. Secure the tent to the ground with tent pegs and,
where necessary, guy ropes.
9. Leave the air vents clear and ensure there is
sufficient ventilation.
Publicidad
