Important Safety Instructions; Description Of The Device; Set-Up And Operation - Lervia KH 4402 Instrucciones Para El Manejo Y La Seguridad

IMPORTANT SAFETY INSTRUCTIONS

The following basic safety instructions must always be observed for all use of
electrical devices:
Please read the following information carefully for safe and correct use of the device.
Before reading, fold out the page with the illustrations and later familiarise yourself with
all functions of the device. Keep these instructions safely and pass them on to any
relevant persons.
– The paper shredder should be operated by only one person at a time.
– Everything that could be accidentally sucked in should be kept well away from the
cutters or from the device, e.g. long hair, ties, etc.
– Never insert a finger into the cutting opening.
– Never leave the device unattended while in operation.
– Keep children well aware from the device.
– If the device is not operating for a longer time, remove the connection from the socket.
– Do not operate the paper shredder with damaged cable or plug. Any devices not
functioning perfectly or that has been damaged must be immediately examined
and repaired by customer service. You will find the relevant service centre in your
country on the guarantee card.
– The paper shredder is designed for brief operating periods.
Uninterrupted operation: maximum two minutes.
– In case of danger, remove the plug from the socket immediately.
– Never use the paper shredder for purposes for which it is not designed or intended.

DESCRIPTION OF THE DEVICE

Cutter top
Collection bin

SET-UP AND OPERATION

First place the cutter top
is attached to the rear. Connect the paper shredder KH 4402 to a 230 V power supply.
1. First remove any clips or staples from the documents to be destroyed.
2. The paper shredder is intended exclusively for cutting paper. Other material could
damage the cutting knives or cause dangerous splinters.
3. Turn the operating switch
4. Insert the paper into the cutting opening
and also switches off automatically when no further paper is inserted. You can cut up to
five pages (80g/m
5. If paper should jam in the device, turn the operating switch
The motor will now run in reverse mode and the paper will be ejected.
6. To switch off the device, turn the operating switch
7. The collection bin
125 sheets DIN A4. Empty the collection bin regularly as required.
N.B.: The device will switch off automatically if overheated. In such cases, pull out the
power connection and let the device cool down. You can then switch it on again.
7 GB
onto the collection basket
to the position »ON/AUTO« (stand-by operation).
2
paper) at the same time.
has a capacity of 15 litres. This corresponds to approx.
Operating switch
Cutting opening
so that the power cable
from above. The motor starts automatically
to the »OFF« position.
into the position »REW«.