Keys and their functions
SET
MODE
SET
MODE
Resetting training information
When you are not cycling, you can reset the ETM, TRP, MAX and AVS training information by
pressing the
ODO (the total number of kilometres cycled on the trainer). Once it has reached 99,999 km it will
automatically reset to 0 km (or miles). All the trip data is also reset when the Flow computer is
switched off. When the computer is restarted everything is set to 0 again, except the ODO.
Function during configuration
Press in combination with MODE key for 10 seconds to enter the SETUP menu
(countdown appears)
Change setting
Change setting
Next step
Exit the SET UP menu
Function during cycling
Select training type based on slope or power
Change training setting
Page through display functions
Change training setting
Page through display functions
Page through MODE functions
Confirm training type
SET
and
MODE
keys at the same time for 2 seconds. It is not possible to reset the
Settings before you begin
When you put the plug into the wall socket, the entire display lights briefly as a test. Then various
parameters are shown for two seconds:
• frequency (50 or 60 Hz) and voltage (110 or 220 V) of the mains power
• version number of the firmware
• scale factor (100%)
• body weight (75 kg)
• speed indication and trip energy consumption (km/h, kJoule)
Then the start screen appears. If you want to use the standard settings, you can begin straight away.
If not, follow the instructions below.
Press
SET
and
MODE
and the body weight flashes.
Weight
Body weight (without bicycle) flashes. You can use the
weight between 40 and 120 kg. Use
Speed
Km flashes. You can change Km to Mi with the
next step.
Energy
Kcal flashes. You can change Kcal to kJoule with the Up arrow
to the next step.
4
at the same time for 10 seconds. Now the text SET UP appears on the display
Up arrow
or
Down arrow
to set the
MODE
to go to the next step.
Up arrow
or
Down
arrow. Use MODE to go to the
or
Down
arrow. Use
MODE
5
EN
NL
DE
FR
ES
IT
CH
to go
JP