1.- FITTING THE ELECTRONIC
MONITOR.-
Place the monitor (62) in the direction
of the arrow sliding the monitor on the
holding plate (M) Fig.1 and fix it with
the screw (71).
Connect the terminal (70) of the cable
sticking out of the main body (A) in
terminal (72) of the rear part of the
monitor (62) Fig.1.
Important:
components in special containers,
Fig.2.
2.-ELECTRONIC MONITOR.-
To give you greater control over the
exercise, this electronic unit provides
simultaneous read-outs of speed, rpm,
distance - exercise time, pulse, level,
and watts-calories burnt.
The screen will switch itself on
automatically as soon as you start
exercising or pressing a key.
After the exercise, the monitor will
display for 60 seconds:
TIME
- Exercise time
AVG SPD - Average speed
DIST
Distance travelled
AVG RPM - Average cadence
AVG PULSE Average heart rate
KCAL
- Kilocalories burned
AVG WATT Average watts
The monitor will switch itself off
automatically if the unit stands idle for
more than 60 seconds, resetting the
values of the session.
Deposit
electronic
English
3.- TELEMETRIC PULSE RATE
To measure your pulse rate during
exercise you will need to wear the
chest band (OPTIONAL). Fig 3.
See telemetric pulse rate instruction
book).
TROUBLESHOOTING GUIDE.-
Problem: Display segments of a
function read-out are not visible or
error
function appear.
Solution:
a.- Make sure that the connection
cables are connected. A and B Fig 4.
b.- Check that the battery (63) is ON.
Fig 4.
c.- Check the battery charge If it is run
down change the battery.
d.- If the above steps do not help then
replace the electronic monitor.
Avoid leaving the electronic monitor in
direct sunlight as this might damage
the liquid crystal display. Similarly, do
not expose it to water or knocks.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
4
messages
for
a
particular