Phasak Kryptos Serie Manual Del Usuario página 21

KRYPTOS
PH 9478
1. Precautions
1.1. Transportation
• Please transport the UPS system only in the original packaging to protect against
shock and damage
• The UPS must be stored in the room where the temperature is well regulated.
Ambient temperature should not exceed 40°C.
1.2. Preparation
• Condensation may occur if the UPS system is moved directly from cold to warm
environment. The UPS system must be absolutely dry before being installed. Please
allow at least two hours for the UPS system to acclimate the environment.
• Do not install the UPS system near water or in moist environments, neither where it
would be exposed to direct sunlight or near heater. Do not block ventilation holes in
the UPS housing.
1.3. Installation
• Do not connect appliances or devices which would overload the UPS system (e.g.
laser printers) to the UPS output sockets.
• Place cables in such a way that no one can step on or trip over them.
• Do not connect domestic appliances such as hair dryers to UPS output sockets.
• The UPS can be operated by any individuals with no previous experience.
• Connect the UPS system only to an earthed shockproof outlet which must be easily
accessible and close to the UPS system.
• Please use only VDE-tested, CE-marked mains cable and power cables to connect
the UPS system to the building wiring outlet (shockproof outlet).
• When installing the equipment, it should ensure that the sum of the leakage current
of the UPS and the connected devices does not exceed 3.5mA.
1.4. Operation
• Do not disconnect the mains cable on the UPS system or the building wiring outlet
(shockproof socket outlet) during operations since this would cancel the protective
earthing of the UPS system and of all connected loads.
• The UPS system features its own, internal current source (batteries). The UPS
output sockets or output terminals block may be electrically live even if the UPS
system is not connected to the building wiring outlet.