Hopper Dust Control Filter; Engine Radiator And Hydraulic Radiator Cleaning - Advance SW8000 Instrucciones De Uso

A-18 / ENGLISH
HOPPER DUST CONTROL FILTER (PANEL FILTER)
The hopper dust control fi lter must be cleaned regularly to maintain the effi ciency of the vacuum system. Follow the recommended fi lter service
intervals for the longest fi lter life.
CAUTION!
Wear safety glasses when cleaning the fi lter.
Do not puncture the paper fi lter.
Clean the fi lter in a well-ventilated area.
Wear appropriate dust mask to avoid breathing in dust.
To remove the hopper dust control fi lter...
1 Unlatch and open the Hopper Cover (16). Make sure that the Hopper Cover Prop Rod (17) is in place.
2 Inspect the top of the Hopper Dust Control Filter (12) for damage. A large amount of dust on top of the fi lter is usually caused by a hole in the
fi lter or a damaged fi lter gasket.
Inspect the bottom of the Hopper Dust Control Filter (12). If the fi lter is covered with wet or dry mud, the dust control system will not function
properly without replacing or thoroughly cleaning the fi lter using Method "C".
3 Remove the four Shaker Assembly Retainer Knobs (13). Lift off the Dust Filter Shaker Assembly (11) to access the panel fi lter.
4 Lift the Hopper Dust Control Filter (12) out of the machine.
5 Clean the fi lter using one of the methods below:
Method "A"
Vacuum loose dust from the fi lter. Then gently tap the fi lter against a fl at surface (with the dirty side down) to remove loose dust and dirt.
NOTE: Take care not to damage the metal lip which extends past the gasket.
Method "B"
Vacuum loose dust from the fi lter. Then blow compressed air (maximum pressure 100 psi) into the clean side of the fi lter (in the opposite
direction of the airfl ow).
Method "C"
Vacuum loose dust from the fi lter. Then soak the fi lter in warm water for 15 minutes, then rinse it under a gentle stream of water (maximum
pressure 40 psi). Let the fi lter dry completely before putting it back into the machine.
6 Follow the instructions in reverse order to install the fi lter. If the gasket on the fi lter is torn or missing, it must be replaced. NOTE: Before
replacing fi lter clear debris from dust plate located under fi lter. Verify that the debris fl ap at the rear of the dust plate swings freely

ENGINE RADIATOR AND HYDRAULIC RADIATOR CLEANING

The engine radiator and hydraulic radiator must be occasionally cleaned to prevent overheating and premature wear of engine and hydraulic
systems. Follow the recommended service intervals.
CAUTION!
Wear Safety glasses when cleaning the engine radiator and hydraulic heat exchanger.
1 Tip back Engine Compartment Cover (1). Disconnect cable latch on the left side of Engine Compartment Cover to allow cover to fully tip
back and out of the way.
2 Turn the locking mechanism at the top of the hydraulic radiator to allow the hydraulic heat exchanger to fully tip back and away from the
radiator for easy cleaning access.
3 Blow out engine radiator and hydraulic radiator with air and or use low pressure water to rinse debris from the fi ns.
NOTE: Do Not use a pressure washer or a mechanical brush to clean fi ns since this can cause damage to the fi ns. If fi ns get bent, carefully
straighten them to improve cooling performance.
4 Restore hydraulic radiator to raised position and latch into place
5 Reconnect Engine Compartment Cover (1) cable and fully return the cover normal operational position
A-18 - FORM NO. 56091065 - SW8000