Important Instructions For Use; Heating Power - therm-ic PowerGloves Modo De Empleo

Turning off: To turn off the Therm-ic
PowerGlove, press and hold down
(3 seconds) the control button "-"
(until the device display turns off).
Regulate: Each time the control button "+"
button is pressed (approx. 1 sec.),
the heat level is increased; with the
"–" button (approx. 1 sec.), you can
lower the heat level. The LEDs on
the control display show the current
heat level (1 LED = low heat, 3
LEDs = high heat).
I M PO R T A NT I NS T R U C T I O N S FO R US E
 Recharge the batteries before each use.
 Make sure that the batteries have been
connected correctly with the glove (connector
latched).
 When starting up, do not allow step 3 to be
switched on longer than a few minutes in each
case, otherwise too much heat can be produced
during operation – danger of burning.
13
 Always set your Therm-ic PowerGloves to level 1
or 2 to maintain a comfortable level of warmth for
your fingers (heating should be almost
undetectable).
 An optimum heat level can been reached when
the gloves are dry.
H E A TI N G P O WE R
Max.
Level temperature*
(°C / °F)
1 37°C / 99°F
2 45°C / 113°F
3 62°C / 144°F
* Measured directly on the heating element under
laboratory conditions
The heating duration per charge depends on the
selected heating level, the ambient temperature
and the age as well as charging status of the
batteries.
Heating period per
battery charge
8 – 10 hours
4 – 5 hours
2 – 2.5 hours