Tabla de contenido
Publicidad
Keep the vehicle and parts in an environment that is within the recommended installation temperature range for 4 hours.
1
REMOVE FACTORY FASTENERS
T15
3
CLEAN
5
MARK
DRAW CENTER HASH MARK WITH GREASE PENCIL
AT CENTER, BOTH SIDES, ON EACH SUPER BOLT
AND SHEET METAL. THIS WILL ENSURE FENDER
FLARE WILL BE CENTERED TO GREASE PENCIL
DATE: 02.27.19
Vehicle and part must be at 16°C or 60°F or more before installation.
FRONT FENDER FLARE
E
OUTLINE.
GM - SILVERADO 2019
INSTALLATION MANUAL
2
REMOVE MUD GUARD
T15
4
PRE-INSTALL & SCREW
FENDER
SPACER
K
6
UNSCREW & REMOVE
USA 800 543 9276
L
APPLY PRESSURE TO THE
SCREW
WHEEL ARCH TIGHTENING
TORQUE 2 NM
(NEWTON-METER)
WASHER
P
10 mm
T15
T15
PG.
2
Publicidad
Tabla de contenido
