Tabla de contenido
Publicidad
32
REMOVE THE SUPER BOLTS SCREWS
34
PRESS SUPER BOLTS STUDS
J
PRESS
A full surface contact between tape and substrate is important for good adhesion performance.
Contact is achieved by applying pressure. In practice a pressure between 40 and 50 N/cm² is usually
needed and an application temperature between 25 and 45 °C or 77 and 113 °F is also necessary.
During application, add-on parts and tapes must have the similar temperature.
DATE: 02.27.19
¼"
INSTALLATION SUPER BOLT
ATTENTION
FULL SURFACE CONTACT IS CRITICAL FOR GOOD
ADHESION PERFORMANCE. ALWAYS APPLY FIRM
PRESSURE WHEN MOUNTING ADD ON PARTS AND
SUPER BOLT STUDS
USA 800 543 9276
GM - SILVERADO 2019
INSTALLATION MANUAL
33
UNSCREW & REMOVE
TAPES.
T15
40-50 N/cm
2
PG.
8
Publicidad
Tabla de contenido
