Tabla de contenido
Publicidad
13
PRESS SUPER BOLTS STUDS
A
J
PRESS
A full surface contact between tape and substrate is important for good adhesion performance.
Contact is achieved by applying pressure. In practice a pressure between 40 and 50 N/cm² is usually
needed and an application temperature between 25 and 45 °C or 77 and 113 °F is also necessary.
During application, add-on parts and tapes must have the similar temperature.
14
PLACE BRACKET Z29
Q
R
DATE: 02.27.19
INSTALLATION SUPER BOLT
ATTENTION
FULL SURFACE CONTACT IS CRITICAL FOR GOOD
ADHESION PERFORMANCE. ALWAYS APPLY FIRM
PRESSURE WHEN MOUNTING ADD ON PARTS AND
SUPER BOLT STUDS
S
USA 800 543 9276
GM - SILVERADO 2019
INSTALLATION MANUAL
TAPES.
40-50 N/cm
2
PG.
4
Publicidad
Tabla de contenido
