Rds Operation; Listening To Traffic Announcements - Jensen MP1524BT Manual Del Propietário

MP1524BT
4. Repeat the above procedure for the remaining 5 pre-sets on that band and for
the other 4 bands on the unit
Mono/Stereo
Press and hold the 7 (ST/MO) button (20) to select either the mono or stereo radio
reception mode. Reception of distant stations can sometimes be improved by
selecting mono reception.
Scan
Press SCAN button (16) to enter scan mode. The unit will scan through the band
in a higher frequency station direction and remain on each station for several
seconds. The corresponding frequency will flash 6 times on the display.

RDS Operation

Using PTY function to Select Program
• Press the PTY button (15) once to enable selection of the PTY program groups.
Once a group is displayed, rotate the volume knob (21) to select the desired PTY
program. Once the desired PTY program group is found, press the
(8) or the button (9). The unit will search for the associated radio station and
stop when a station is found.
• With PTY enabled, press the PTY button (15) again to cancel the PTY function.
NOTE: When the unit is set to AREA EUR in system settings, whenever RDS function
is enabled AF will appear on the display. With PTY enabled, press the PTY button
(15) again to cancel the PTY function.

Listening to Traffic Announcements

• Press and hold the EQ button (17) and the unit will search for traffic
announcements automatically. TA SEEK will appear on the display and the
unit will search until the function is disabled. To disable the search for traffic
announcements, press and hold the EQ button (17).
button
19