Jensen MP1524BT Manual Del Propietário página 28

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5. A prompt to pair or bond should appear on your mobile phone. Accept the
request and initiate the process.
NOTE: Some mobile phones require a "pass key" or pairing code to connect. If your
phone requires a pass key or pairing code, you will need to enter this number. The
default pairing code for many mobile phones is "0000" or "1234"". The default code
for the unit is "0000".
6. A prompt to enter a PIN number or passkey for the unit should appear. The
default passkey for the unit is "0000".
7. At this point a prompt stating pairing successful should appear. Another
prompt should appear asking connect to the unit, Yes or NO. Press Yes. The
mobile phone and the unit should connect. The mobile phone should display
a message similar to "Device Connected" and the mobile phone and the unit
are now connected. CARBT_JENSEN will appear on the mobile phone list of
devices.
8. When successfully paired, the Bluetooth® symbol
unit's display panel. If the pairing process failed, wait for minute and try to pair
again.
NOTE: During the pairing process, only the volume knob (21) and Power On/Off
( )/MUTE button (1) are functional. The other keys are disabled. If you want to
terminate the pairing process, press and hold the MODE/PAIR button (5) and
PAIRED END will appear on the LCD display.
Bluetooth® Reconnect Feature
The unit has a built-in automatic Bluetooth® reconnect function. The unit will
automatically reconnect with a mobile phone as long as the mobile phone
has been paired with the unit before. Be sure that the Bluetooth symbol
displayed on the unit's display panel.
The unit will connect with a mobile phone within ten seconds under the following
conditions:
a. The unit is turned off and then turned on again.
b. Turning the ignition switch from the ACC position to OFF and then returning to
the ACC position.
Button button (4), and NOT PAIRED may be displayed on the LCD.
Press the
You can wait for several seconds to let the unit to reconnect automatically or press
and hold the SCAN # Button (12) for several seconds to reconnect. During the
connection process the unit's display panel will display CONN TRY. When the unit
successfully connects to the mobile phone CONNECT OK will be displayed.
26
MP1524BT
will be displayed on the
is

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido