Removing The Unit; Din Rear Mount (Method B) - Jensen MP1524BT Manual Del Propietário

Removing the unit

1. Make sure the ignition is turned off, and then disconnect the cable from the
vehicle battery's negative (-) terminal.
2. Remove the metal strap attached to the back of the unit (if attached).
3. Press the release button to remove the front panel.
4. Lift the top of the outer trim ring then pull it out to remove it.
5. Insert both of the supplied keys into the slots at the middle left and right sides
of the unit, then pull the unit out of the dashboard.

DIN Rear Mount (Method B)

If your vehicle is a Nissan or Toyota, follow these mounting instructions.
1. Use the screw holes marked T (Toyota), N (Nissan) located on both sides of the
unit to fasten the unit to the factory radio mounting brackets supplied with
your vehicle.
2. To fasten the unit to the factory radio mounting brackets align the screw holes
on the bracket with the screw holes on the unit and then tighten the screws
(5x5mm) on each side.
NOTE: The outer trim ring, sleeve and the metal strap are not used for method B
installation.
6
MP1524BT