Addressing; Dmx-Protocol - EuroLite WMS 8 Manual Del Usuario

All manuals and user guides at all-guides.com

Addressing

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED WMS 8-fold set RBG will respond to the controller.
For address setting, press the Up/Down-buttons until the display shows "A001" and set the desired address
via the Up/Down-buttons.
Controlling:
After having addressed the LED WMS 8-fold set RBG, you may now start operating it via your lighting
controller.
Note:
After switching on, the LED WMS 8-fold set RBG will automatically detect whether DMX 512 data is received
or not. If the data is received, the control LED flashes. If there is no data received at the DMX-input, the
control LED lights up permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the LED WMS
8-fold set RBG.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.

DMX-protocol

L I
Control channel 1 – Each spot occupies 6 channels. Eight spots occupy 48 channels.
1~6 7~12 13~18 19~24 25~30 31~36 37~42 42~48
L2
Control channel 2 – Every 2 spots occupy 6 channels. Eight spots occupy 24 channels.
1~6 7~12 13~18 19~24
17/35 51930200X18NXS_V_1_0.DOC