Operation; Examine The Chain Oil; Start The Machine; Stop The Machine - GreenWorks 20192 Manual Del Operador

1. Form a loop at the end of the extension cord (15).
2. Put the loop portion of extension cord through opening at
the bottom of the rear handle.
3. Place over cord retainer (16).
4. Pull the loop against cord retainer until the slack is
removed.
5. Plug the machine into the extension cord.
9

OPERATION

WARNING
Before you plug in, examine if the rated mains voltage and
mains frequency, as tell on the rating label, match your
power supply.
WARNING
Before operation, examine if the mains connection cable
and extension cable have damage. Only use the mains
connection cables and extension cables in good condition.
IMPORTANT
Examine the chain tension before each use.
It is recommended to use the cord retainer in the rear handle
to prevent accidental disconnection of the power supply.
9.1

EXAMINE THE CHAIN OIL

NOTE
Do not use the machine without sufficient chain oil.
1. Examine the oil level of the machine from the oil
indicator.
2. Add the oil if it is necessary.
9.2

START THE MACHINE

English
15
16
1. Connect the machine to power supply.
2. Pull the lock-out button (3) with your thumb backward.
3. Press the trigger (1) at the same time.
9.3

STOP THE MACHINE

1. Release the trigger to stop the machine.
9.4

CUTTING PREPARATION

Before you start to cut, make sure that
• Wear heavy gloves for maximum grip and protection.
• Maintain a proper grip on the machine during operation.
• Use your right hand grip on the rear handle while
your left hand grip on the pole shaft.
• Keep your body to the left of the chain line.
• Never use a left-handed (cross-handed) grip, or any
stance that places your body or arm across the chain
line.
• Never stand directly under the limb you are cutting.
• Periodically examine the tightness of the collars during
operation.
9.5

DELIMBING A TREE

B
A
WARNING
Make sure that there is nothing or nobody in the area where
the branches fall.
• Stand opposite the branch you will cut.
• Start to cut the higher branches.
• Then cut the lower branches.
• Cut downwards to prevent the bar from jamming.
9.6

LIMB TREE BRANCHES

Limbing is to remove the branches from a fallen tree.
9
EN