Assemble The Guide Bar And The Chain; Fit The Pole Saw; Connect The Machine To The Power Supply - GreenWorks 20192 Manual Del Operador

EN
8.3 ASSEMBLE THE GUIDE BAR AND
THE CHAIN
1. Loosen the chain cover by turning the chain cover knob
(17) counterclockwise.
2. Remove the chain cover.
3. Put the chain drive links (21) into the bar groove (20).
4. Put the chain cutters (22) in the direction of the chain
operation.
5. Put the chain in position and make sure that the loop is
behind the guide bar.
6. Hold the chain and bar.
7. Put the chain loop around the sprocket (18).
8. Make sure the chain tension pin hole (19) on the guide
bar fits correctly with the bolt.
18
9. Install the chain cover.
17
22
21
20
19
English
10. Tighten the chain. Refer to Adjust the chain tension.
11. Tighten the chain cover knob when the chain is correctly
tensioned.
If you start the chain saw with a new chain, have a test for
2-3 minutes. A new chain gets longer after the first use,
examine the tension and tighten the chain if necessary.
8.4

FIT THE POLE SAW

2
1. Mount the pole saw head (13) on pole saw handle (2) to
achieve the standard length.
2. Slide the collar (11) upwards.
3. Turn the collar clockwise to tight it.
8.5 FIT THE POLE SAW
1. Mount the pole saw head on pole saw handle to achieve
the standard length.
2. Slide the collar upwards.
3. Turn the collar clockwise to tight it.
8.6 CONNECT THE MACHINE TO
THE POWER SUPPLY
The machine has a cord retainer.
8
NOTE
11
13
NOTE