Accessing The System Remotely - Dell Networking S3048 Guía De Inicio

Accessing the System Remotely

You can configure the S3048–ON system to be accessed remotely by Telnet.
The system has a dedicated management port and a management routing
table that is separate from the IP routing table.
1. Configure an IP address for the management port (Configuring the
Management Port IP Address).
2. Configure a management route with a default gateway (Configuring the
Management Route).
3. Configure a username and password (Configuring the Username and
Password).
Configuring the Management Port IP Address
In order to access the system remotely, assign IP addresses to the
management ports.
1. Enter INTERFACE mode for the Management port.
CONFIGURATION mode
interface ManagementEthernet slot/port
2. Assign an IP address to the interface.
INTERFACE mode
ip address ip-address/mask
3. Enable the interface.
INTERFACE mode
no shutdown
Configuring the Management Route
Define a path from the S3048–ON to the network from which you are
accessing the S3048–ON remotely.
Management routes are separate from IP routes and are used to manage the
S3048–ON through the management port.
• Configure a management route to the network from which you are
accessing the system.
CONFIGURATION mode
25