Cleaning And Servicing; Cleaning The Base Unit - Bosch MUM6N Serie Instrucciones De Uso

en
Blender
(some models)
Figure C
 Remove protective cover from the blender
drive.
To do this, press the back of the protective
cover and remove the cover.
 Place the protective cover on the drive
for bowl/tools.
 Attach the blender and rotate all the way
in an anti-clockwise direction.
Ensure that the marks on the blender and
appliance are in alignment!
 Add ingredients.
– Maximum amount of liquid
ingredients = 1.25 litres;
– Maximum amount of frothing or
hot liquids = 0.5 litres;
– Optimum processing amount of solid
ingredients = 100 grams.
 Attach the cover and as far as possible
in a clockwise direction.
The lug on the blender cover must be fully
located in the slot in the blender handle!
Blender will not work unless the cover has
been attached and locked.
 Set the rotary switch to the desired setting.
10
Important information
When working, hold the blender cover
by the edge.
Adding more ingredients
 Switch off the appliance with the rotary
switch.

Remove the cover and add ingredients
or
 take out the funnel on the blender cover
and gradually add solid ingredients via the
feed tube
or
 pour liquid through the funnel.
After using the appliance
 Switch off the appliance with the rotary
switch.
 Pull out the mains plug.
 Rotate the blender in a clockwise direction
and remove.
Tip: It is recommended to clean the blender
immediately after use.

Cleaning and servicing

Cleaning the base unit

 Pull out the mains plug.
 Wipe the base appliance and protective
cover with a damp cloth. If required, use
a little washing-up liquid.
 Then dry the base unit.
Robert Bosch Hausgeräte GmbH