Fermax 1088 Manual De Instrucciones página 36

INTERFACE TELEFONICO
INTERFACE TELEFONICO
PROGRAMMING USER PARAMETERS
The User Parameters are those that may be modified most often in line with the user's needs. The
following table shows what these are:
Digit Parameter
Divert Telephone.
3
Telephone number calls will be diverted to.
Call ring duration.
4
Lets you modify the lenght of the ring sound.
Call divert activation.
7
Lets you activate the divert from the telephone.
Call divert deactivation.
8
Lets you deactivate the divert from the telephone.
√ √ √ √ √ NOTES:
Maximum length of the divert telephone is 16 figures.
•
It is not necessary to enter any value for divert activation or deactivation.
•
It is possible to activate or deactivate the divert by means of an additional switch (see
•
installation diagrams).
PROGRAMMING EXAMPLE
To program the divert Telephone, proceed as follows:
1- Unhook the telephone handset you want to program the Interface from.
2- Press three times the '#' key. The PRG LED will light up and the dialling tone stops.
3- Key in the digit corresponding to the parameter you wish to program.
In this example it would be 3
4- Key in the new parameter value, in this case the telephone number
you want to divert the door call to. For example: 612 345678
5- Press '#' again to exit programming mode or wait 30 seconds without pressing any keys.
The telephone number to which the call will be diverted has now been programmed (in this case a mobile
phone). Remember that the maximum length of the divert number is 16 digits.
14
Value
System
TELEPHONE
BOTH
NUMBER
BOTH
1-255
BOTH
NO
NO
BOTH