Fein SCW 16-6 Manual De Instrucciones página 10

SCW 16-6 - Buch Seite 10 Montag, 18. März 2002 10:23 10
EN
Handling.
Switching ON/OFF (3).
First check that the cable and plug are
not damaged.
Switching the power tool ON:
Press switch (3).
Switching the power tool OFF:
To turn off, let go of switch.
Selecting the direction of
rotation (2).
Set the switch to the direction of
rotation, clockwise (R) or anti-clock-
wise (L).
Only operate when power tool is at a
standstill.
Changing the tool (1).
!
Risk of injury
by switching the tool ON unintentionally.
Before changing the tool, pull out the mains
plug.
Mount the hexagon socket tools (a) on
the drive square.
Cleaning and care.
!
Risk of injury
by switching the tool ON unintentionally.
Before cleaning, pull out the mains plug.
Carry out the following once a week, or
more often if the power tool is used more
frequently:
Clean the venting openings.
Blow out the motor space from outside
with dry compressed air.
10
Maintenance and repairs.
!
Risk of injury
Service, testing and repairs may only be car-
ried out by electrical engineers in conformity
with the regulations valid in the respective
country.
Maintenance and repairs.
We recommend our customer service
department (repair centre), FEIN author-
ised service centres and agencies.
Addresses can be found at the end of
these operating instructions and in the
enclosed safety instructions.
Please hand these operating instructions
to the repair centre. An overview of spare
parts can be found at the end of these
operating instructions.
Upon request a repair manual is sent to
the electrical engineers.
Only use original FEIN spare parts.
Maintenance work.
Grease the lubricating nipple (4) on the
tool holder (drive shaft) monthly, or
more regularly during more frequent
use or greater load.
Spare parts.
The overview of spare parts is at the end
of these operating instructions. Quoting
the parts no. (1), reference no. (2) as well
as the number of spare parts (3) facilitates
the ordering procedure.
SCW 16-6