Technical Data - Zanussi ZWI 71000 WA Manual De Instrucciones

Problem
The machine vibrates is
noisy:
Spinning starts late or the
machine does not spin:
The machine makes an un-
usual noise:
No water is visible in the
drum:
If you are unable to identify or solve the prob-
lem, contact our service centre. Before tele-
phoning, make a note of the model, serial num-
ber and purchase date of your machine: the
Service Centre will require this information.

Technical data

Dimensions
Electrical connection
Water supply pressure
Level of protection against ingress of solid particles and moisture
www.zanussi.com
The transit bolts and packing have not been removed.
• Check the correct installation of the appliance.
The support feet have not been adjusted
• Check the correct levelling of the appliance.
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
Maybe there is very little laundry in the drum.
• Load more laundry.
The electronic unbalance detection device has cut in because the laun-
dry is not evenly distributed in the drum. The laundry is redistributed by
reverse rotation of the drum. This may happen several times before the
unbalance disappears and normal spinning can resume. If, after 10 mi-
nutes, the laundry is still not evenly distributed in the drum, the machine
will not spin. In this case, redistribute the load manually and select the
spin programme.
• Redistribute the laundry.
The load is too small.
• Add more items, redistribute the load manually and then select the
spinning programme.
The machine is fitted with a type of motor which makes an unusual noise
compared with other traditional motors. This new motor ensures a softer
start and more even distribution of the laundry in the drum when spin-
ning, as well as increased stability of the machine.
Machines based on modern technology operate very economically using
very little water without affecting performance.
Width / Height / Depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
Possible cause/Solution
Mod. ... ... ...
Prod. No. ... ... ...
Ser. No. ... ... ...
60 / 85 / 54 mm
220-230 V
2000 W
10 A
50 Hz
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
IPX4
19