Pairing Collar Tags; Fitting Collar Tag To Your Pet; Replacing Collar Tag Batteries; Low Battery Indicator - Pet-Corp PC7 Manual De Instrucciones

ENGLISH
4

6. PAIRING COLLAR TAGS

1. Press the Tag Button for 5 seconds or more (but less than 10). A Red LED will flash for 15
seconds, during this period the door is ready for you to pair a tag.
2. Hold the collar tag close to the door. A Green LED will flash to indicate that the tag has been
detected.
3. Press the Tag Button for 5 seconds or more (but less than 10) to store the tag. The LED will
remain green for 2 seconds to indicate the tag has been successfully paired with the door.
You may pair up to 16 tags.
Old Tag: If the tag is already in the memory, the green led light will turn on for 2 seconds to
indicate it.
Memory full: If the memory is full, the tag reader function will
cancel and the LED will flash red for 2 seconds to indicate that no
more tags can be added.
7. WIPING ALL TAGS FROM THE MEMORY
In the unlikely circumstance you need to wipe all tags from the
doors memory, press the Tag Button for 10 seconds or more, a
Red LED will light for 2 seconds to indicate that the memory has
been wiped and it is now empty (16 tags erased).
You may not erase an individual tag.

8. FITTING COLLAR TAG TO YOUR PET

To ensure the collar tags work well they should be attached directly to your pets collar and the
collar should not be over or under tightened. The tag should sit on the front of your pet's neck in
front of it's throat.

9. REPLACING COLLAR TAG BATTERIES

Collar tag batteries will need to be replaced approximately every 12 months. Simply twist the
back cover off using a coin and swap the battery with a fresh new CR2032 cell. Ensure it is
inserted the correct way around with the positive side facing up.
Do not leave a battery in an unused tag. It will drain the battery.

10. LOW BATTERY INDICATOR

Low battery: When the battery is low the door will become unlocked (to prevent locking the pets
inside or outside) and a red LED will flash once a minute until the batteries are dead.
The low battery indicator may last for a few days. You should replace the batteries or revert to
power as soon as you see the low battery indicator to keep the door operating normally.

11. REPLACING THE DOOR FLAP

To remove the door flap press and hold the
10), the Red LED will flash for 2 seconds to indicate that the door has been unlocked and turned
off. Be sure to turn it back on again once the flap has been replaced.

12. TROUBLESHOOTING

Symptom: The Door is not closed properly
• Check that the door is turned on and the batteries are not flat
• Check the door flap for obstructions and remove them.
Symptom: The door isn't letting my pet in or out
• Check that the Cartridge is turned on and the batteries are not flat, replace the batteries if
necessary
• Check that the collar tag is still attached to your pet's collar
• Check that both magnets are in the bottom of the door flap
Symptom: The batteries are going flat very quickly
The door is designed to be in sleep mode until the cat activates the door by touching the flap
which then switches the door to active mode. Do not place the door in a windy location as the
flap may be activated by a strong wind which will reduce the battery life.
Check the weatherseal on the flap to ensure there is no build-up of debris, preventing the flap
from closing properly.

13. MAINTENANCE

Keep the door clean:
To prevent the door flap from jamming it should be kept clean and free of debris at all times.
Power Button for 5 seconds or more, (but less than
ENGLISH
5