CASUALPLAY Avant Manual De Instrucciones página 21

Ocultar thumbs Ver también para Avant:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 3
levers on both sides should be set to the upper position. To lock them in place, press
the levers downwards, they will click when locked into place.
Hood
(illustration 19)
• The hood is fastened to the seat, only the upholstery may be taken off to be washed.
Follow the washing instructions printed on the care label of the hood.
• Unfasten the zip on the front part of the hood, undo the Velcro and clips on the sides (fig. 19).
• Unfasten the Velcro on the back of the pushchair backrest.
• To fit the upholstery back on follow the same steps in reverse.
Folding
(illustrations 20–21)
NOTE: The Avant can be folded with or without the seat in place.
WARNING: The Avant cannot be folded with the complements (sono, prima, prima
fix, nuno/folk, baby 0+, newmoon, metropol).
Folding
with the seat facing forwards (illustration 20)
• Fold the hood and place the backrest in the horizontal position
• Slide the two catches on the sides of the handlebar.
• Push the handlebar forwards.
• Fold the chassis fully and check that the locking device (coloured red) has secured the
chassis to prevent it from opening accidentally.
Folding
in the reverse position, with the seat facing backwards (illustration 21)
• Fold the hood.
• Move the armrest forwards, and place the seat backrest in the folding position.
• Slide the two catches on the sides of the handlebar.
• Push the handlebar forwards.
• Fold the chassis fully and check that the locking device (coloured red) has secured the
chassis to prevent it from opening accidentally.
Fitting the rain cover
NOTICE: THIS RAIN COVER SHALL NOT BE USED ON A PUSHCHAIR NOT FITTED
WITH A CANOPY TO INSTALL IT.
• Unfold the hood.
• Place the rain cover on top of the Avant, take care when fitting the rain cover to make
sure that the openings are at the back of the pushchair.
• Pass the handlebar through the openings and fasten the Velcro strips.
• Lastly, fasten the two Velcro strips to the basket.
Fitting/removing the harness
• Pass the buckles of the harness through the vents in the seat and the mattress pad.
(illustration 22)
(illustration 23)
19

Publicidad

Tabla de contenido
loading

Tabla de contenido