Cosatto NITTY GRITTY WOOP Manual De Instrucciones página 4

5 - using the swivel wheel lock
Press down on the lever (a). Swivel the wheel until it locks in the forward facing position. The wheel
will now only travel straight ahead (b).
Lift the lever (c) to release the lock. The wheel will now swivel from side to side (d).
6 - removing the basket
Undo the press studs at the back on the inside of the basket (a) and on the outside at the bottom
of the basket (b). Release the clips (c) at the front of the basket.
Re-fitting is a reversal of this procedure.
7 - folding the chassis
While pressing the release button (a), pull the two levers (b) back. Press down on the handle (c)
closing the chassis until the autocatch retains the chassis in the folded position (d).
The handle position is adjustable and can be folded inwards (e) to achieve the most compact fold.
Whilst pressing on both buttons on both sides of handle, adjust the handle position move the
handle up or down and let go at desired hand position.
Note: The chassis can only be folded with the seat unit installed forward facing in the most upright
recline position.
8
- fitting and removing the seat unit
Place the seat unit on to the mounting points on each side of the chassis. Push down until the
tabs locate in the holes of the seat mountings (a).
To remove the seat unit from the chassis, press the buttons on each side of the mountings (b) then
lift the seat unit free (c).
Note: The seat unit can be fitted forward facing (d) or parent facing (e).
9
- adjusting the recline position
The pushchair seat can be adjusted to 3 different positions of recline. Press the buttons (a) located
on both sides of the pushchair seat simultaneously and move to the desired position (b & c) until a
positive click is heard.
WARNING: Never adjust the seat unit with your child in the seat.
Note: Please note that in from birth mode, the seat unit must only be used in its most recline
position (horizontal), parent facing.
10
- using the seat unit in from birth mode
When using the seat unit in from birth mode, fasten only the top buckle (a) & middle buckle (b).
Ensure that the zips (c) on either side of the seat unit are open and recline the seat to its most
reclined position (See step 9, d).
The seat is now ready to be used in from birth mode.
Note: From birth mode is not a substiute for a pram and the harness must be used at all times.
The seat must only be used in its most reclined (horizontal) position, parent facing.
11
- using the seat unit in older child mode
When the child is ready to progress to more upright recline position, the seat unit can be used in
the older child mode.
When using the seat unit in older child mode, fasten only the bottom buckle (a) and ensure that
the zips (b) on either side of the seat unit are fully fastened.
The seat is now ready to be used in older child mode.
12 - fitting, lifting and removing the bumper bar
Fit the bumper bar by pushing each end into the seat unit mountings until the clips lock in place (a).
To open the bumper bar press the clip on one side of the mounting (b) and lift the bumper bar clear
(c). Repeat this procedure at the other end of the bumper bar to remove the bar from the seat.
The bumper bar cover can be detached from the bumper bar by unzipping the cover at the back (d).