LaserLiner DuraMax Manual De Instrucciones página 16

Single slope function up to 5°
In automatic mode, an axis can be manually set to a certain slope using this function, even if the
ADS tilt function is also active. This means that one axis can be re-adjusted whilst the other is
aligned horizontally. Press the slope/man button to activate the function and select the X or Y axis.
The slope LED flashes, as does the LED for the X or Y axis. The slope is re-adjusted using the
plus/minus buttons. ATTENTION: This function cannot be used to perform full horizontal levelling,
just to adjust one axis.
DuraMax / DuraMax XPro
optional
function
1 X axis
Constant
illumination
Slow
flashing
Constant
illumination
Application example: A gradient is to be laid out at the entrance to a garage. For this, one axis must be
re-adjusted and the other aligned horizontally with the garage floor.
IMPORTANT: If a horizontal line is to be moved simultaneously on one wall, the X or Y axis of the rotary
laser must be aligned at right angles to the wall. If this is not done, a slope will be projected onto the
wall. Use the reference beam to set the right angle.
16 GB
optional
function
2
± 5°
Constant
illumination
Slow
flashing
Constant
illumination
Commander 50
3 Y axis
2x
or
Constant
illumination
Slow
flashing
Constant
illumination
4
± 5°
Constant
illumination
Slow
flashing
Constant
illumination