Precautions - Onkyo BD-SP309 Manual De Instrucciones

Precautions

1. Recording Copyright—Unless it's for personal
use only, recording copyrighted material is
illegal without the permission of the copyright
holder.
2. AC Fuse—The AC fuse inside the unit is not
user-serviceable. If you cannot turn on the unit,
contact your Onkyo dealer.
3. Care—Occasionally you should dust the unit
all over with a soft cloth. For stubborn stains,
use a soft cloth dampened with a weak solution
of mild detergent and water. Dry the unit
immediately afterwards with a clean cloth. Don't
use abrasive cloths, thinners, alcohol, or other
chemical solvents, because they may damage
the ¿ nish or remove the panel lettering.
4. Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR
THE FIRST TIME, READ THE FOLLOWING
SECTION CAREFULLY.
AC outlet voltages vary from country to country.
Make sure that the voltage in your area meets
the voltage requirements printed on the unit's
rear panel (e.g., AC 200-240 V, 50/60 Hz or AC
120 V, 60 Hz). The power cord plug is used to
disconnect this unit from the AC power source.
Make sure that the plug is readily operable
(easily accessible) at all times. Pressing the
ON/STANDBY button to select Standby mode
does not fully disconnect from the mains. If you
do not intend to use the unit for an extended
period, remove the power cord from the AC
outlet.
5. Preventing Hearing Loss
Caution
Excessive sound pressure from earphones and
headphones can cause hearing loss.
6. Batteries and Heat Exposure
Warning
Batteries (battery pack or batteries installed)
shall not be exposed to excessive heat as
sunshine, ¿ re or the like.
7. Never Touch this Unit with Wet Hands—
Never handle this unit or its power cord while
your hands are wet or damp. If water or
any other liquid gets inside this unit, have it
checked by your Onkyo dealer.
8. Handling Notes
• If you need to transport this unit, use the
original packaging to pack it how it was when
you originally bought it.
• Do not leave rubber or plastic items on this
unit for a long time, because they may leave
marks on the case.
• This unit's top and rear panels may get warm
after prolonged use. This is normal.
• If you do not use this unit for a long time, it
may not work properly the next time you turn
it on, so be sure to use it occasionally.
• When you've ¿ nished using this unit, remove
all discs and turn off the power.
9. Installing this Unit
• Install this unit in a well-ventilated location.
• Ensure that there's adequate ventilation all
around this unit, especially if it's installed in
an audio rack. If the ventilation is inadequate,
the unit may overheat, leading to malfunction.
• Do not expose this unit to direct sunlight
or heat sources, because its internal
temperature may rise, shortening the life of
the optical pickup.
• Avoid damp and dusty places, and places
subject to vibrations from loudspeakers.
• Never put the unit on top of, or directly above
a loudspeaker.
• Install this unit horizontally. Never use it on its
side or on a sloping surface, because it may
cause a malfunction.
• If you install this unit near a TV, radio, or
VCR, the picture and sound quality may be
affected. If this occurs, move this unit away
from the TV, radio, or VCR.
10. To Obtain a Clear Picture—This unit is a
hightech, precision device. If the lens on the
optical pickup, or the disc drive mechanism
becomes dirty or worn, the picture quality
may be affected. To maintain the best picture
quality, we recommend regular inspection
and maintenance (cleaning or worn part
replacement) every 1,000 hours of use
depending on the operating environment.
Contact your Onkyo dealer for details.
11. Moisture Condensation
Moisture condensation may damage this
unit.
Read the following carefully:
Moisture may condense on the lens of the
optical pickup, one of the most important parts
inside this unit.
• Moisture condensation can occur in the
following situations:
- The unit is moved from a cold place to a
warm place.
- A heater is turned on, or cold air from an air
conditioner is hitting the unit.
- In the summer, when this unit is moved
from an air conditioned room to a hot and
humid place.
- The unit is used in a humid place.
• Do not use this unit when there's the
possibility of moisture condensation
occurring. Doing so may damage your discs
and certain parts inside this unit.
If condensation does occur, unplug the power
cord and leave the unit for two to three hours in
the room temperature.
En
3