Technical Data - Hansgrohe AXOR Citterio 39451000 Instrucciones De Montaje

Assembly
Important! The fitting must be installed, flushed
and tested after the valid norms.
The hot and cold supplies must be of equal
pressures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
The flow is changed from bath to shower function
by pulling the knob at the upper side of the spout.
After shutting off the water flow, the mixer returns
automatically to the bath function.

Technical Data

Operating pressure:
Recommended operating pressure: 0.1 - 0.5 MPa
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.: 65° C
Rate of flow by 0.3 MPa:
Anti-pollution function
Fault
Insufficient water
Mixer stiff
Mixer dripping
Instantaneous heater didn't work - Filters are dirty
8
English
max. 1 MPa
1,6 MPa
max. 80° C
approx. 15,3l/min
Cause
- Shower filter seal dirty
- Cartridge defective, calcified
- Cartridge defective
Hansgrohe single lever mixers can be used toge-
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0.15 MPa.
Spare parts (see page 3)
1 handle
2 flange
3 nut
4 cartridge cpl.
5 aerator cpl.
6 selector assy
7 diverter knob
8 hose 1,25 m
9 filter packing(5)
10 handshower
Remedy
- Clean filter seal between shower
and hose
- Exchange cartridge
- Exchange cartridge
- Clean the filter / exchange filter
39091000
96671000
97157000
96339000
13956000
97978000
96466000
28282000
94246000
28531000