Black and Decker GL675 Manual De Instrucciones página 5

Do not expose the appliance to rain or high humidity.
Before using the appliance, check that your cutting path is
x
free from sticks, stones, wire and any other objects.
Only use the appliance in the correct position, with the
x
cutting line near the ground, as shown in the illustrations.
Never switch the appliance on in any other position.
Switch on the appliance only when hands and feet are
x
away from the cutting line.
Avoid body contact with the cutting line while the
x
appliance is running.
Do not work on steep slopes. Be sure of your footing. Be
x
aware that freshly cut grass is damp and slippery.
Take care when trimming near borders and gravel paths
x
or roads, as stones and soil may be moved by the cutting
line.
Do not put the appliance down until the cutting line has
x
come to a complete standstill.
Use only the appropriate type of Black & Decker cutting
x
line. Never use metal cutting line or fishing line.
After extending new cutting line, always return the
x
appliance to its normal operating position before
switching on.
Take care to keep the mains cable away from the cutting
x
line. Always be aware of the position of the cable.
Features
This tool includes some or all of the following features.
1. Trigger lever (on/off switch)
2. Handle
3. Cable restraint
4. Power inlet
5. Secondary handle
6. Handle knob
7. Adjustment button
8. Cable storage hooks
9. Motor housing
10. Guard
11. Line trimming blade (see fig. F)
12. Spool housing
13. Cutting line
14. Line storage pouch
15. Tube
16. Spool storing position
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting the guard (fig. A)
Remove the screw (17) from the guard (10).
x
Place the guard onto the tool as shown.
x
Firmly press the guard until it snaps into place.
x
Secure the guard with the screw.
x
Warning! Never use the tool unless the guard is properly fitted.
Fitting the secondary handle (fig. B)
Place the handle (5) on the tool as shown.
x
Adjust the handle to the most comfortable position.
x
Use the markings as a guide.
Pass the bolt (6) through the secondary handle and the
x
main handle.
Screw the bolt into the far side of the secondary handle.
x
Do not overtighten the bolt.
Storing the spool not in use (fig. C)
The cutting system not in use can be stored in the position
provided (16).
Align the tabs on the cutting head with the cut outs (25)
x
at the underside of the handle.
Push the cutting head into the handle until it snaps
x
securely into place.
Releasing the cutting line
In transit, the cutting line is taped to the spool housing.
Remove the tape holding the cutting line (13) to the spool
x
housing (12).
Connecting the tool to the mains
Connect the female plug of a suitable extension cable to
x
the power inlet (4).
Loop the cable through the cable restraint (3).
x
Insert the mains plug into a mains outlet.
x
For wired in cable units: Make sure the cable is looped
through the cable restraint prior to connecting the plug to
the mains outlet.
Warning! The extension cable must be suitable for outdoor use.
Use
Warning! Let the tool work at its own pace. Do not overload.
Setting the tool to trimming or edging mode (fig. D, E & F)
The tool can be used in trimming mode as shown in fig. D or in
edging mode to trim overhanging grass along lawn edges and
flower beds as shown in fig. E.
Trimming mode (fig. D & F)
For trimming, the trimmer head should be in the position
shown in fig. D. If it is not:
Depress the adjustment button (7).
x
Rotate the head (9), while releasing the button.
x
ENGLISH
5