Waves SL-100577 Manual De Instrucciones página 4

STORAGE
Remove the mains plug from the wall socket.
Pour any remaining water out of the water reservoir.
Set the steam knob to no steam position.
Stand the iron upright and let a cool down sufficiently.
CLEANING
Before cleaning the Iron ensure it is disconnected from the power supply and has
completely cooled down.
Deposits on the soleplate may be removed with a rough cloth soaked in a vinegar water
solution.
The casting may be wiped with a damp cloth and then polished with a fry one.
Do not use abrasives on the soleplate.
Keep the soleplate smooth. Avoid hard contact with metal objects.
TIPS
Which type of water to use?
Your appliance has been designed to function with untreated tap water. If your water is very
hard, it's possible to mix untreated tap water with storebought distilled or demineralised
water in the following proportion: 50% tap water / 50% distilled water.
Which type of water not to use?
The types of water listed below contain organic waste or mineral elements that can cause
spitting, brown staining, or leakage: water from clothes dryers, scented or softened water,
water from air conditioners.
If problems occur?
Water drips from the holes
in the soleplate.
Brown streaks
through the holes in the
soleplate and stain the
linen.
The chosen temperature is
too low and does not allow
for the formation of steam.
You are using steam while
the iron is not hot enough.
You have stored the iron
horizontal,
emptying it and without
switching off the steam
function.
come
You are using chemical
descaling agents.
Fabric fibers
accumulated in the holes of
the soleplate
burning.
- 3 -
Position the thermostat to
the maximum temperature
setting.
Wait until the control light
goes out.
Empty the iron after each
without use, and store it vertical.
Do not add any descaling
agents to the water.
have Let the iron cool down and
clean the soleplate with a
and are sponge. Vacuum the holes of
the soleplate from time to
time.