DeWalt D28127 Manual De Instrucciones página 24

E N G L I S H
Mounting the side handle (fig. E)
• Screw the side handle (5) tightly into one of the
holes (17) on either side of the gear case.
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Ensure all materials to be ground or cut
are secured in place.
• Apply only a gentle pressure to the tool.
Do not exert side pressure on the disc.
• Avoid overloading. Should the tool
become hot, let it run a few minutes
under no load condition.
Prior to operation:
• Install the guard and appropriate disc or wheel.
Do not use excessively worn discs or wheels.
• Be sure the inner and outer flange are mounted
correctly.
• Make sure the disc or wheel rotates in the direction
of the arrows on the accessory and the tool.
Switching on and off (fig. A)
• To run the tool, press the on/off switch (1).
• For continuous operation, press the switch
completely forward.
• To stop the tool, release the switch. To stop the
tool in continuous operation, press on the back
part of the switch.
Do not switch the tool on or off when
under load.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D WALT Power Tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
24
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
Unwanted tools and the environment
Take your tool to an authorized D
agent where it will be disposed of in an
environmentally safe way.
WALT repair
E