Adjusting The Current Channel Level - Sherwood RD-606i Instrucciones De Funcionamiento

RD-606i(G)_ENG_110511_RD-606i(G)_ENG 2011-05-13 오전 9:57 페이지 20

Adjusting the current channel level

• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit
your tastes.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user's memory ("CAL"),
not into preset memory("REF 1", "REF 2").
1.
Press the CHANNEL LEVEL button.
CH.LEVEL
MODE
V I D E
• Then the memory mode ("CAL", etc.) is displayed for
several seconds.
• When the memory mode or channel level disappears,
press this button again.
2.
Select the desired channel.
PRESET
• Each time these buttons are pressed, the corresponding
channel is selected as follows:
→REF 1, 2 (or CAL) ↔ LEFT ↔ CENTER ↔ RIGHT ←
→ <DD or DTS> ↔ SUBW ↔ SURR L ↔ SURR R ←
< >: Possible only when the digital signals from Dolby Digital or
DTS program sources that includes LFE signal are input.
• Depending on the speaker settings ("NO") and surround
mode, etc., some channels cannot be selected.
• When the SPEAKER button is set to off, only the Front
Left, Front Right (and LFE) channels can be selected.
AT HDMI
: CA L
O 1 ( HDM I 1 )
3.
Adjust the level of the selected channel as
desired.
TUNE
• The LFE level can be adjusted within the range of -10 ~ 0 dB
and other channel levels within the range of -15 ~ +15 dB.
• In general, we recommend the LFE level to be adjusted to
0 dB.(However, the recommended LFE level for some
early DTS software is -10 dB.) If the recommended levels
seem too high, lower the setting as necessary.
4.
Repeat the above steps 2 and 3 to adjust each
channel level.
20