Connecting Speakers; Terminal For Upgrades - Sherwood RD-606i Instrucciones De Funcionamiento

RD-606i(G)_ENG_110511_RD-606i(G)_ENG 2011-05-13 오전 9:57 페이지 8
7.

CONNECTING SPEAKERS

• Be sure to connect speakers firmly and correctly
according to the channel(left and right) and the polarity
(+ and -). If the connections are faulty, no sound will be
heard from the speakers, and if the polarity of the speaker
connection is incorrect, the sound will be unnatural and
lack bass.
• For installing the speakers, refer to "Speaker placement"
on page 9.
• After installing the speakers, first adjust the speaker
settings according to your environment and speaker
layout.
(For details, refer to "SETTING THE SPEAKER SETUP"
on page 42.)
Caution :
• Be sure to use the speakers with the impedance of 6
ohms or above.
• Do not let the bare speaker wires touch each other or any
metal part of this unit. This could damage this unit and/or
the speakers.
• Never touch the speaker terminals while the AC input
cord is connected to the wall AC outlet. Doing so could
result in electric shocks.
■
Connecting speaker wire
1. Strip away approx. 10 mm
(3/8 inch) of wire insulation,
then twist the wire ends
tight.
8.
AC INPUT CORD
• Plug the cord into a wall AC outlet.
9.

TERMINAL FOR UPGRADES

• This terminal may be used in the future to update the operating software so that it will be able to support new digital audio
formats, etc.
■Note :
• Programming for upgrades requires specialized programming knowledge and for that reason we recommend that it only be
done by qualified installers.
2. Loosen by turning the
speaker terminal counter-
clockwise.
8
FRONT SURROUND
(6 ) (6 )
R L R
SPEAKERS
3. Insert the bare part of the
wire.
CENTER
(6 )
L
4. Tighten by turning it
clockwise.