Inserting A Memory Card; Using The Digital Photo Frame - AgfaPhoto AS1150 Manual Del Usuario

Inserting a Memory Card

1 Insert a memory card which is not read-only
into the appropriate card slot at the rear of the
device. Your photo frame supports the follow-
ing memory cards: SD, xD, MMC, MS, MS Pro.
DANGER!
Inserting a Memory Card!
Only use storage media that are com-
patible with the device. In order to
prevent damage to the card or the
unit, please turn off the power before
removing or inserting the card.
Never pull out the memory card while
the device is accessing it. This could
cause data to be damaged or lost.
2 Press the button h.
3 Wait until the indicator light for the device sta-
tus is constantly on.
Notice
Control Lamp
If this control lamp flashes, this could
stem from one of the following caus-
es.
- no memory card inserted
- insufficient memory capacity availa-
ble on the memory card (less than
1MB)
- The read-only option of the memory
card is active
- memory card defective
Please note that the initialisation
process of a memory card with a ca-
pacity of 2GB or more takes longer.
The control lamp can blink for up to
20 seconds

Using the digital photo frame

If the device is connected to a compatible digital
photo frame, the scanned photos can be trans-
ferred directly to the memory of the digital photo
frame.
1 Press and hold the h key to switch off the de-
vice.
2 Connect the digital photo frame to the Mini-
USB socket of the device using a USB cable.
3 Switch the device on using the h button.
EN
5