Cleaning The Scanner Glass; Computer Connection; Connecting To The Computer - AgfaPhoto AS1150 Manual Del Usuario

14 Remove the film guide after all negativ film /
slides are scanned. To do so, pull it out gently
and evenly from the document feed.
EN
Notice
Stand-by Mode
If the scanner has not been used for
approx. 15 minutes, it automatically
switches off.

Cleaning the Scanner Glass

Clean scanner glass AS 1110
If lines appear on the scanned image or the image
is not sharp, you need to clean the scanner glass.
1 Switch the device off.
2 Insert the cleaning pen into the left hand end
of the document ejector.
Notice
Instructions for Cleaning
The cleaning pen must be free of any
dust.
3 Move the cleaning pen carefully two or three
times to the other end of the document ejector.
4 Move the cleaning pen to the left hand side of
the document ejector again and then remove
the cleaning pen.
8

Computer Connection

You also use the scanner as a memory card reader
in combination with a computer.
Your computer must meet the following minimum
requirements:
Operating System
Operating System
Windows: Windows 2000 · XP · Vista · or later ver-
sions · 32 bit or 64 bit
Macintosh: Mass Storage Class Mac OS10.5 or lat-
er versions

Connecting to the Computer

Hot-Plug-and-Play
The device is Hot-Plug-and-Play capable which
means you can link your computer to the device,
whilst its running. You do not need to close down
your computer to link the device to it.
1 Connect the device to your computer by means
of the USB cable.
2 If the USB is working correctly, the device is
recognised automatically. A drive letter is as-
signed to each memory card slot.
Notice
Connecting to an USB hub
If you would like to connect the de-
vice to a USB hub = (USB distributor),
ensure that the USB hub is connect-
ed to the computer before you con-
nect the device to the USB hub.
3 You can access the memory card (drive) and
edit the saved files.