Publicidad
14
www.raider.bg
holes should be done gradually, as periodically
removed from the drill hole to remove chips or
dust. If during drilling to drill holes in zaklini, you
should exclude drill. Use a change of direction
of rotation to remove the drill from the hole. Drill
must be kept in alignment with the hole. Ideally,
the drill should be placed perpendicular to the
surface of the material being processed. If the
condition for perpendicularity is not respected
at work can lead to trapped or breakage in drill
hole and injury to the user. Continued drilling at
low speed the engine from overheating threatens.
Must make periodic breaks during work or to
allow the drill to work on no-load maximum speed
for about 3 minutes. Do not obscure the openings
in the hull used for ventilation of the engine.
8.10. Outdoor use.
Switch the machine only in installations
equipped with electric switch "Fi" RCD (Residual
Current Device). RCD must be no more than 30
mA. Use an extension cord suitable for outdoor
use. Use of a cord suitable for outdoor use
reduces the risk of electric shock.
Make periodic breaks at work.
Keep and refer to the accessories carefully.
Do not throw the tool, do not overload, do not
soak in water and other liquids do not use it for
mixing adhesives and concrete coatings.
9. Service and support.
9.1. Electric drill does not require additional
lubrication or special maintenance. There are no
parts requiring maintenance by the user. Never
use water or any liquid chemical cleaning drill. It
should only be wiped with a piece of dry tissue.
Should always be stored in a dry place and
ventilation holes in the body of the drill to be free.
9.2. Replacing carbon brushes.
Exports (shorter than 5 mm), up or broken
engine carbon brushes should be replaced.
Always replace both brushes simultaneously.
Work
on
replacement
entrusted only to qualified person with original
spare parts in service of business RAIDER.
9.3. The repair of your power is best carried
out only by qualified specialists in workshops
RAIDER, which used only original spare parts.
Thus ensuring their safe operation.
of
carbon
brushes
10. Environmental protection.
In view of environmental power, additional
accessories and packaging must be subjected
to appropriate processing for reuse of the
information contained in these materials.
Do not dispose of household waste power!
Under the EU Directive 2002/96/EC on scrapped
electrical
and
electronic
promoting law and national power, which can be
used more, must be collected separately and be
subjected to appropriate processing for recovery
of contained therein scrap.
equipment
and
Publicidad
