Double Insulation - Black and Decker GA100 Manual De Instrucciones

•
Always keep the power supply cable away from
the machine - be aware of its position at all times.
•
Never carry your machine by the cable or jerk
the cable to separate the connectors. Keep the
cable away from heat sources, oils or sharp
edges. Check the condition of your cable before
use and do not use if damaged.
•
You can use an extension cable up to 40m
(130ft). This must be 2 core only, not lighter than
PVC sheathed flexible cord, code designation
H05VV-F, with 1.0mm
For Australia/New Zealand use extension cords
complying to all regulations.
Clothing
•
Always wear gloves when operating the
shredder (H4).
•
We recommend the wearing of protective eye
glasses when operating the shredder (H2).
•
To protect your feet, always wear stout shoes
or boots.
•
Wearing shoes with rubber or man-made soles
will enhance your safety.
•
Do not use the shredder barefoot or in
open sandals.
•
Where long trousers to protect your legs.
•
Always use ear protection if the sound level (H3)
seems uncomfortable when using your machine.
•
Do not wear loose jewellery.
•
Protect long hair from contact with the shredder.
Safety of others
•
Do not allow children or any person who has not
read this instruction leaflet or who is not familiar
with the shredder to operate it.
•
Do not allow children, animals or other persons
near your machine when in use - always keep
them at least 6m (20ft) away from the shredder.
•
Remember that the operator/user is responsible
for accidents or hazards occuring to other
people or their property.
Working conditions
•
Ensure that the shredder is standing on firm
ground when in use.
•
Do not use your shredder in the rain or in
wet conditions (H7).
•
Use only in daylight or good artificial light.
Using your machine
•
Always be sure your machine is in a safe
operating condition.
•
Before using your machine, disconnect it from
the electrical supply and check that the blade,
blade bolts and cutter assembly are not worn or
damaged. Damaged blades and worn bolts are
major hazards and must be replaced.
2 copper cross section.
ENGLISH
•
Under no circumstances should you attempt to
turn your machine over on to its side whilst
running, or attempt to stop the blade - always
allow it to stop on its own. Do not put hands or
feet near or under rotating parts.
•
Never operate the shredder with defective
guards or shields (H6).
•
Replace worn or damaged parts for safety.
•
Do not look directly into the funnel or shredder
outlet while operating the shredder, as loose
debris may be ejected. We recommend the
wearing of protective eye glasses when
operating the shredder.
•
Under no circumstances put your hands in the
cutting area whilst the cutters are still rotating.
The blades will continue to rotate for a short
while after the machine is switched off.
•
Never start the shredder without the body and
large feeder funnel being securely attached.
•
Do not switch the motor off until the shredder is
completely empty, as it may clog and be difficult
to restart.
•
Ensure that no hard objects, e.g. metal, stones
or glass, come into contact with the blades.
Care of your machine
•
Store your machine in a dry place when not in
use, out of the reach of children.
•
Do not use solvents or cleaning fluids to clean
your machine - use a blunt scraper to remove
grass and dirt. Always disconnect from the
electrical supply before cleaning.
•
Do not operate your machine if any parts are
defective; discard all defective parts and fit new
parts before use.
•
Use only Black & Decker recommended
replacement parts and accessories.
•
Keep all nuts, bolts and screws tight to be sure
your machine is in a safe working condition.

Double insulation

Your machine is double insulated. This
means that all external metal parts are
electrically isolated from the power supply.
This is achieved by placing an extra
insulation barrier between the electrical and
mechanical parts. Double insulation means
greater electrical safety and obviates the
necessity of having the machine earthed.
3