Black and Decker GA100 Manual De Instrucciones página 5

Fitting the 'female' connector
(UK only)
To remove the cover, unscrew the fixing screw until it
is free of the nut which is located in the hexagonal
recess on the underside of the connector.
Take care not to lose the nut if it falls out.
There is no need to completely remove the fixing
screw as it is intended to remain captive in the cover.
The cover can now be removed by applying
pressure as follows.
The extension cable contains two wires which are
colour coded for easy recognition; brown is for 'Live'
(L) and blue is for 'Neutral' (N). The female connector
is marked 'L' for live and 'N' for neutral. These
markings are located inside the body near the
terminal screws (see opposite, figure a). With the
connector cover removed, lift out the cable protector
and proceed as follows:
•
Pass the cable through from the narrow end of
the cable protector (see opposite, figure a).
•
Prepare the cable ends to the specified strip
lengths (see opposite, figure b).
•
Remove cable clamp (see opposite, figure a).
Take care of loose parts.
•
To connect the extension cable to the connector
terminals, unscrew the terminal screws until the
clamp washers have lifted just enough to enter
the conductor between the raised washer and
the terminal (see below). Connect the brown
lead to 'L' and the blue lead to 'N'. N.B. There is
no need to remove the terminal screws.
Connections are not to be made under the
screw heads.
clamp
washer conductor position
apply
pressure here
terminal screw
terminal
to left of screw
ENGLISH
•
Locate the cable and cable protector into the
body correctly (see opposite, figure a). Then fit
the cable clamp over the outer sheath of the
cable and screw down until the screws are fully
home. Failure to do this may result in the cover
not fitting correctly to the connector body.
•
Before replacing the cover of the 'female'
connector make sure that the cable clamp is
holding the outer sheath of the cable firmly with
screws fully home and that the two leads are
correctly fixed at the terminal screws and are not
taut (see opposite, figure a).
•
Place the cover onto the body assembly
ensuring that it seats flat, then retighten the
fixing screw into the nut until the cover is
securely held (see opposite, figure c).
•
Finally check that the cable protector is secure
and that there are no gaps between the cover
and the connector body.
cable
clamp
cable
protector
Fitting a new mains plug (UK only)
Fit a
BS1363A
approved
plug
Connect blue
to N (neutral)
Make sure that the
outer sheath of the
cable is held firmly
by the clamp
terminal screws
clamping washers
connector body fixing screw
6mm
cover
Fit the
recommended
fuse
Connect brown
to L (live)
240 volts AC only.
Never use a light
socket
5