Chicco Scaldabiberon Pappacalda Manual De Instrucciones página 8

warmer is completely cold before moving, storing or cleaning it, or before carrying out maintenance
operations, or when not in use.
• Place the feeding bottle warmer only on fl at, stable surfaces, out of reach of children. Never place
the equipment near cradles or cots, since, during use, the container and the water contained in it
become very hot. Always use and handle the equipment with the maximum care! Danger of burns!
• Never place the feeding bottle warmer on top of, or near hot surfaces, gas rings or electric hot plates,
or on delicate surfaces sensitive to heat and/or humidity.
• Never operate the feeding bottle warmer without water inside the heating chamber.
• Only use feeding bottles made of heat-resistant plastic or thermo-resistant glass: do not use dispos-
able feeding bottles.
• Do not move the feeding bottle warmer during use or when it still contains hot liquids.
• After use, always allow the feeding bottle warmer cool down completely.
• When not in use, and before cleaning or storing the feeding bottle warmer, always disconnect the
power cable's plug from the mains socket, and let it cool down completely.
• Before feeding baby, always check the temperature of contents (it must not exceed 37°C).
• For hygiene and health reasons, feeding bottle warmers must only be used to warm up pre-cooked
baby food, not to cook it. It is recommended to warm up food at 37°C. Never warm up food more
than once, or for more than one hour.
• The fi nal temperature of the food and the heating time could vary according to the quantity of food
being heated, the initial (room or fridge) temperature, the density of the food, the position of the
temperature adjustment knob, as well as the type and size of feeding bottle used (plastic or glass
feeding bottle, baby food jar).
The use of any electrical equipment requires compliance with some fundamental rules. In particular:
• The electrical system of the room must always conform to the safety regulations in force.
• Ensure that the equipments' voltage and frequency (see the rated voltage plate located underneath
the equipment) correspond to the voltage and frequency of the mains.
• Plug the equipment to a mains socket that is easily accessible.
• Do not pull the mains cable or the appliance to unplug the equipment from the mains.
• The feeding bottle warmer must be used in compliance with the instructions supplied.
• Do not leave the feeding bottle warmer exposed to atmospheric agents (rain, sun, etc.).
• Do not submerge or wet the plug, feeding bottle warmer, or power cable in water or other liquids.
• Never touch the feeding bottle warmer with wet or damp hands.
• Do not touch the feeding bottle warmer if it has fallen accidentally in the water. Should this hap-
pen, unplug the equipment immediately and do not use it; contact a qualifi ed technician or one of
Artsana S.p.A.'s authorised retailers.
• If the feeding bottle warmer is damaged and / or not working correctly, switch it off and disconnect
the plug from the mains socket; do not attempt to open the product, contact a qualifi ed technician
or one of Artsana S.p.A.'s authorised retailers.
• Never leave the equipment unattended when in use.
• Do not leave the feeding bottle warmer switched on continuously for over 60 minutes.
• After one hour of continuous operation, the equipment must always be switched off and allowed to cool down.
• The feeding bottle warmer can be opened only with special tools. To replace the power cable, only
use a cable similar to the cable supplied with the equipment. The cable must be replaced by a quali-
fi ed technician or one of Artsana S.p.A.'s authorised retailers.
• Do not attempt to open or repair the feeding bottle warmer. If necessary, contact a qualifi ed techni-
8