GYS NOMAD POWER 20 Manual De Instrucciones página 6

This manual contains safety and operating instructions. Read it carefully before using the device for the first time and keep it in a
safe place for future reference.
SAFETY
- Do not use to charge non rechargeable batteries.
- If damaged, the power supply cable will need to be replaced.
- Do not cover the device whilst using it.
- Do not store or use the device in a room where the temperature is above 70°C.
- Do not modify of dissassemble the product.
- Protect against rain and moisture.
- This product should be disposed of at an appropriate recycling facility. Do not dispose of in domestic waste.
This device is not intended for use by persons (including children) with reduced physical or mental capabilities, or lack of experience
and knowledge, unless they have been given by a person responsible for their safety, supervision or instructions concerning the use
of the device. Children must no play with the product. Cleaning and maintenance should not be performed by unsupervised children.
- The device must be positioned so that the socket is always accessible.
OPERATION
Indicators
Lights
Internal battery
capacity for the
device
Indicators flash in turn, whilst charging the device. The number of indicators ON indicates the capacity of the NOMAD POWER internal
battery. All lights are steady if the battery is on hold or the charge is complete.
!
RECHARGE THE NOMAD POWER before first use and after each use.
INTERNAL BATTERY CHARGING
OR
STARTING THE VEHICLE
Emergency start function for petrol or diesel vehicles with a 12V battery.
To start a vehicle, please process as follows:
!
If the voltage of the vehicle battery is > 12.5V, the NOMAD POWER will not function properly.
1
6
NOMAD POWER 20
Press the power button
1 flashing 1 steady
0% 25%
1 - Connect mains adaptor to domestic mains.
2 - Connect the other end to the NOMAD POWER 14V/1A to start the charge.
1 - Connect car adaptor to the car cigarette lighter socket.
2 - Connect the other end to the NOMAD POWER 14V/1A to start the charge.
Connect the jumper cable to the NOMAD POWER connector.
to check internal battery level of the NOMAD POWER.
2 steady
50%
3 steady 4 steady
75% 100%
EN