Overview (Fig. A); English - Black and Decker HP9012 Manual De Instrucciones

Under extreme conditions, battery leakage may occur.
When you notice liquid on the battery, proceed as follows:
- Carefully wipe the liquid off using a cloth. Avoid skin
contact.
- In case of skin or eye contact, follow the instructions
below.
Warning! The battery fluid, a 25-30% solution of potassium
hydroxide, can be harmful. In case of skin contact, immediately
rinse with water. Neutralise with a mild acid such as lemon
juice or vinegar. In case of eye contact, rinse abundantly with
clean water for at least 10 minutes. Consult a physician.
Do not incinerate the battery.
Do not attempt to charge damaged batteries.
Chargers
Use your Black & Decker charger only to charge the battery
in the tool with which it was supplied. Other batteries
could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
Have defective cords replaced immediately.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The charger is intended for indoor use only.
Electrical safety
Your charger is double insulated; therefore no earth
wire is required. Always check that the mains
voltage corresponds to the voltage on the rating
plate. Never attempt to replace the charger unit with
a regular mains plug.

Overview (fig. A)

1. Variable speed switch
2. Forward/reverse slider
3. Bit holder sleeve
4. Head adjustment button
5. Charger receptacle
6. Charger
7. Screwdriver bit
8. Battery
Assembly
Fitting and removing the battery (fig. B)
To fit the battery (8), line it up with the receptacle on the
tool. Slide the battery into the receptacle and push until
the battery snaps into place.
To remove the battery, push the release button (9) while
at the same time pulling the battery out of the receptacle.
Fitting and removing a drill bit or screwdriver bit
(fig. C & F)
This tool uses screwdriver bits and drill bits with a 1/4"
(6.35) mm hexagonal shank.
Lock the tool by setting the forward/reverse slider (2) to
the centre position (fig. F).
Pull back the bit holder sleeve (3) (fig. C).
Insert the bit shaft (7) into the bit holder.
Release the bit holder sleeve.
Use
Warning! Before drilling into walls, floors or ceilings,
check for the location of wiring and pipes.
Charging the battery (fig. E)
The battery needs to be charged before first use and whenever
it fails to produce sufficient power on jobs that were easily
done before.
When charging the battery for the first time, or after
prolonged storage, it will only accept an 80% charge.
After several charge and discharge cycles, the battery will
attain full capacity. The battery may become warm while
charging; this is normal and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 4 °C or above 40 °C. Recommended charging
temperature: approx. 24 °C.
To charge the battery (8), remove it from the tool.
Slide the charger receptacle (5) onto the battery as
shown.
Plug in the charger (6).
The battery will become warm while charging. After approx. 3
hours of charging, the battery will be fully charged.
Remove the charger receptacle from the battery.
Adjusting the head (fig. D)
For optimum versatility, the head can be set to different positions.
Press the head adjustment button (4) down.
Swivel the head into the desired position.
Release the button.
Selecting the direction of rotation (fig. F)
For drilling and for tightening screws, use forward (clockwise)
rotation. For loosening screws or removing a jammed drill bit,
use reverse (counterclockwise) rotation.
To select forward rotation, push the forward/reverse
slider (2) to the left.
To select reverse rotation, push the forward/reverse slider
to the right.

ENGLISH

5